$45.00 $29.25

Tesla, GM & Mazda Brake Bleeder Cap (for 3-tab twist cap)
[BleedCap2]

Weight: 1.00 lbs

Brake Reservoir Cap Adapter (Tesla, GM & Mazda) - I had a limited run of quality brake bleeder caps produced locally when I was selling big brake kits. Bleeder caps are required for pressurizing the hydraulic system when bleeding calipers, clutch slave cylinders and wheel cylinders.

These are made of 6061 anodized aluminum (not plastic) with a 1/4" NPT inlet for your canister type pressure bleeder or regulated air supply. They were originally targeted for GM and Mazda vehicles with round 3-tab twist lock reservoir caps. I recently discovered that they also fit Tesla (model 3 for sure).

A spare gasket is included with each cap for future replacement or in case you need to double them up for a tighter seal when pressurizing the hydraulic system. The cap gaskets are 1/8" thick and made of 40 durometer Buna-N (nitrile rubber).

Fits the following............

Tesla

  • Model 3
  • Model Y
  • not sure yet about models X, S or the roadsters

Cadillac

  • 32V Northstar 1996-
  • Eldorado TC 1996-
  • Seville SLS 1996-
  • Seville STS 1996-
  • SRX 2003-
  • CTS (DOT3) 2001-
  • XLR 2003-

Chevrolet

  • Alero 1999-
  • Blazer 1996-
  • Blazer 1999-
  • Camaro 1999-
  • Corvette 1996-
  • Hummer H2 + H3 2003-
  • S10 Pick-Up 2WD + 4WD 1996-
  • Tahoe 2003-
  • Trans Sport 1999-
  • Trail Blazer 2001-

Mazda

  • Mazda 6 (2003-)
  • MPV (2001-)
  • RX-8 (2003-)

Pontiac

  • Firebird + Cabrio
  • Trans Sport

Made in USA (Bergenfield, NJ)

Reviews

0 items
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search