3/4" ID Water Heater Connector - 3/4 x 12" - recommended for maximum water flow
through 3/4" pipe. Great for most water heater and water
softener connections. This hose is 3/4" ID with 3/4"
FIP connectors ("Female Iron Pipe"....ie, Female NPT)
on both ends. Available in 6 different lengths - 12",
15", 18", 24", 36" and 48".
Falcon hoses will not discolor,
corrode or rust nor will they crimp or kink. Other features
- 304 Series Corrugated
- Full Port - no rubber or
plastic hose or inserts to reduce flow
- Stronger and more flexible
- Re-usable and Re-bendable
- Minimal deformity in
Curvature...these hoses will hold a bend
- Burst pressure rated to
- Re-Usable and Re-Bendable
- No Galvanic Effect (no
dielectric union is needed)
- All fittings are chrome
plated solid brass
- High temp EPDM Washer
(-40Â° to 220 Â°F)
- 100% leak tested
- Falcon Warranty
** The fittings on the 3/4"
FIP hoses can be tightened with an adjustable wrench or a 1
3/16" (30mm) open end wrench. Please do not use a pipe
wrench. I personally like Facom's 70A series
ratcheting flare wrench
as this contacts the fitting on all 6 points and is less damaging
to the chrome plating. This wrench retails for over $100 but is
currently available at a 50+% savings.