Facom
Flange Press for SAE, DIN and SAE/DIN Fittings (347)(Additional
Freight, see below)-
line flaring tool that works with copper and stainless steel
pipework (4.75 - 12mm or 3/16" - 1/2" in diameter and
wall thickness 0.7 - 1.0mm). Use it for brake, oil cooler and
fuel lines to make 45 degree single, double and bubble flare
ends. Most European cars use bubble flare ends.
- Press can be secured in a
vice for increased stability
- Fast and effortless forming
of flared ends
- Kit includes 11 punches and
9 dies. Instructions explain selection according to
flange type
- SAE/DIN....6mm, 8mm, 10mm
and 3/16"
- SAE and DIN - 4.75mm
- SAE and SAE/DIN -
1/4", 5/16" and 3/8"
- SAE and SAE/DIN - 12mm
(1/2")
- Comes in a steel case
- 396x224x82mm
- Weight - 7.9kg
Note - the stock Facom photo
shows 10 tube retaining dies. Facom has reduced this to 9 dies by
combining the 5/16"/8mm size.
Freight - $10 flat rate shipping for USPS
zones 1-4 (see zone chart image, click to enlarge). If you are
located beyond zone 4, the item will be shipped via Fedex Ground
(additional $10-30 freight cost). Actual shipping will be quoted
before the order is sent.